After selecting innings overide, the innings figures not allinging as they had prior times. Match report screens show correct, but not in admin mode. The example above, I have not even entered bowling for Eaglehawk, only our club.
Also showing incorrect wickets. Only 2 out here. 2 not out and 2 retired/not out.
After a bit of detective work, I found your match:
https://www2.cricketstatz.com/ss/w.aspx?club=31781&mode=100&match=3054297
When I looked it up, I can see the following data:
The batting and bowling figures are all in sync with the override figures for innings 1 and 2. The admin console pulls this data and displays it. Can you go back into that innings and check? It should be fine.
Can you think of what you may have done to go back to the old match results screen? Maybe hitting the back button after saving perhaps? I will see if I can work out how you managed to do it.
Also, the 4 wickets are only showing for innings 3 since you did the override to 4 wickets. If you either correct the override to 2 or set it back to 0 then it will show correctly as 2.
And a tip - if you are not capturing balls faced then you can turn this off for this division by editing the division and turning off Show Balls Faced on Batting Card: